3-85
D Input Using the Teaching Function
Operation Display Explanation
Change the status to display the cam number to which the teaching
function is to be applied.
ON/
OFF
SET
+
Press the Set Key while pressing the ON/OFF Switching Key.
The ON angle can now be input.
The present angle will be flashing in the SPEED/ON display.
(Manual
operation of
machinery)
Using manual operation, move the machine to the ON angle position.
SET
Press the Set Key to set the ON angle and change the status to
enable OFF angle input.
Note Press the Clear Key to re-set the ON angle. The system will return
to the ON angle input status.
(Manual
operation of
machinery)
Using manual operation, move the machine to the OFF angle position.
SET
Press the Set Key to set the OFF angle.
The ON and OFF angles for the step created using the teaching
function will be displayed in the SPEED/ON and POSITION/OFF
displays.
ON/
OFF
SET
+
To apply the teaching function to the next step in the same cam
number, press the Set Key while pressing the ON/OFF Switching Key
again.
Repeat the same operation as described above.
Note If the ON or OFF setting overlaps with the ON region for the next step when the Set Key is pressed
to save those settings, an E23 (cam program duplication error) will be generated. Press the Clear
Key if this error occurs. The error will be cleared and the status will return to the angle settings that
generated the error.
If an E23 (cam program duplication error) occurs, check the contents of the already input cam
program. Refer to Deleting Cam Program Steps on the next page for information on how to delete
the relevant step.
Operation Chapter 3
To Next Page
Loading...
