Omron 3F88L-160 - Page 71

3-15
Classifi-
cation
Refer-
ence
Function levelContentsFunctionClassifi-
cation
Refer-
ence
2
(All
func-
tions)
1
(Basic
opera-
tion/
monitor
only)
0
(Moni-
tor
only)
ContentsFunction
Basic
functions
Cam program writing Writes and edits cam
programs (settings for
cam output ON/OFF
angles)
No Yes Yes 3-5-3
Program number checking Checks the number of
cam program steps.
Yes Yes Yes 3-5-3
Origin compensation When the ADJ switch
is pressed in SET
mode, the present
Resolver angle at that
time is changed to 0
or to the origin
compensation value.
Yes Yes Yes 3-5-5
Cam output (from cam
output connector)
While the START
signal is ON in RUN
mode, the cam
outputs for the
specified bank
number are turned
ON or OFF according
to the cam program
and present Resolver
angle.
Yes Yes Yes 3-5-6
Operation Chapter 3