7-3 CompoWay/F Slaves Connected to a Computer
7-3-1 Reading from Slaves Connected to the Computer
The CompoWay/F network
configuration is displayed in the
Network Configuration Window.
new CompoWay/F network
is added in the Workspace
Window.
The CX-Thermo application will receive the Temperature Controller model number
and start. After the parameter settings are completed, download the set values to
the E5ZN.
Refer to the CX-Thermo Help function for details on setting parameters and
downloading parameter settings to components.
Note
• When connecting the computer and CompoWay/F Slave, use a K3SC Serial
Converter to convert between the computer’s RS-232C communications and the
CompoWay/F Slave’s RS-485 communications.
7-13
To Next Page
Loading...
Need help?
General