Omron CX-INTEGRATOR - V1.1 - Page 36

1-4 PLC Connecting Cables
1-4-1 Direct Serial Connections to a PLC
Unit Unit port Computer
Computer
port
Network type
(serial
communications
mode)
Model Length Remarks
CPU Unit Built-in
peripheral port
IBM
PC/AT or
compatible
D-sub 9-pin
male
Peripheral bus
(Toolbus)
or Host Link
(SYSWAY)
CS1W-CN118 +
XW2Z-200S-CV/
500S-CV
0.1 m +
2 m/5 m
The
XW2Z-@@@
S-CV uses a
connector
with ESD
(electrostatic
discharge)
countermeas
ures.
IBM
PC/AT or
compatible
D-sub 9-pin
male
Host Link
(SYSWAY)
CS1W-CN118 +
XW2Z-200S-V/
500S-V
0.1 m +
2 m/5 m
---
CS1W-CN118
Peri
p
heral
p
ort
XW2Z-@@@S-@@
RS-232C cable
(listed above)
Connection to
RS-232C Port
Note The following connection methods can be used when connecting an CQM1-CIF01/02
cable to a peripheral port on a CS/CJ-series PLC.
Unit Unit port Computer
Computer
port
Network type
(serial
communications
mode)
Model Length Remarks
CPU Unit Built-in peripheral
port
IBM
PC/AT or
compatible
D-sub 9-pin
male
Host Link
(SYSWAY)
Note: Baud rate
must be 19.2
Kbits/s or less.
CS1W-CN114 +
CQM1-CIF02
05 m +
3.3 m
---
CS1W-CN114
Peri
p
heral
p
ort
CQM1-CIF01/02
Peripheral Cable
Connection to
RS-232C Port
1-16