Omron E5GN - Page 74

E5GN
5–7
Run/Stop
This parameter specifies run and stop.
When  : run" is selected, control is running. When  : stop" is selected, conĆ
trol is stopped. When control is stopped, the display lights.
Default is 
".
Alarm value 1
The alarm type must be set to other than
upper and lower limit alarm.
This parameter sets the input value X" in the alarm type list.
Ă• This parameter is used for setting the alarm values of alarm outputs.
Ă• During temperature input, the decimal point position is dependent on the currently
selected sensor, and during analog input it is dependent on the decimal point"
parameter setting.
Setting Range Unit Default
-1999 to 9999 EU 0
The alarm type must be set to other than upper and lower limit alarm.
FĂRelated parameters
Input type" Scaling upper limit" Scaling lower limit" Decimal point"
Alarm 1 type" (initial setting level)
Alarm 1 open in alarm" Alarm 1 hysteresis" Standby sequence reset method"
Alarm latch" (advanced function setting level)
Operation Level
Function
Function
Setting
See