4
Setting the Controller
This section describes settings related to the system environment for the controller.
4-1 Selecting Language [Startup Settings] ...................................................... 4 - 2
4-2 Setting the Status at Startup [Startup Settings]........................................ 4 - 3
4-3 Setting Communication [Startup Settings]................................................ 4 - 6
4-4 Setting Operation Mode [Startup Settings].............................................. 4 - 11
4-4-1 Setting the Operation Mode.........................................................................4 - 11
4-4-2 Parallel Processing ..................................................................................... 4 - 27
4-5 Checking the Camera Connections [Camera Connection] .................... 4 - 38
4-6 Setting the Trigger Delay [Inter-camera Setting]..................................... 4 - 39
4-6-1 Trigger Delay Setting .................................................................................. 4 - 39
4-7 Setting the SHTOUT Signal [Output Signal Settings]............................. 4 - 42
4-8 Setting the Conditions Related to Communications .............................. 4 - 45
4-9 Setting Date/Time [Date/Time Settings] ................................................... 4 - 46
4-10 Setting Fan Control [Fan Control Setting] ............................................... 4 - 48
4-11 Setting the Pulse Width for the STEP Input Detection [STEP Sig-
nal Filter Setting]......................................................................................... 4 - 49
4-12 Setting Encoder Trigger [Encoder Trigger Setting] ................................ 4 - 50
4-13 Setting Network Drive [Network Drive Setting] ....................................... 4 - 52
4-14 Setting Screen Capture [Screen Capture Setting] .................................. 4 - 55
4-15 Setting the Conditions that are Related to Operation during
Measurement [Measurement Conditions]................................................. 4 - 56
4-16 Setting Logging Conditions [Logging Setting] ....................................... 4 - 58
4-17 Setting Operation Log [Operation Log Setting] ...................................... 4 - 59
4-18 Setting the Operation at Error [Error Setting] ......................................... 4 - 60
4-19 Setting Character Code using Macro/Variable Function [Macro/
Variable Function Setting] .......................................................................... 4 - 62
4-20 Changing Display Settings for Screen Keyboard [Screen Key-
board Settings]............................................................................................ 4 - 63
4 - 1
FH/FHV Series Vision System User’s Manual (Z365-E1)
4