Chapter 8: Maintenance
The battery compartment door is capable of being locked. You may need to unlock it
before opening.
3.
Disconnect the power and data cables before removing the battery.
4.
Slide the battery back and out of the platform.
There is a hand grip at the front and the rear of the battery, to help you lift it.
Installation
Refer to Removing and Installing Skins on page 150 for details on removing and installing
skins.
1.
Remove the battery door skin.
a.
Pull the bottom of the skin away from the platform chassis.
This is easiest if you grip it with two hands, toward the center.
b.
Lower the skin down enough that its top tab clears the rear skin.
2.
Unlatch and open the battery compartment door.
The battery compartment door is lockable, and you might need to unlock it.
3.
Lift and slide the new battery into the platform body.
The battery weighs 19 kg.
The battery has recesses at the front and the back for easier lifting.
Figure 8-4. Battery Recesses, for Gripping
A single person can lift and replace the battery. Use one hand in each of the grips, as
shown in the following figure.
11970-000 Rev M LD-60/90 Platform User's Manual 135
To Next Page
Loading...
