Omron LD-90 - Battery; Installing the Battery; Removing the Battery Door Skin

44 LD-60/90 Platform User's Manual 11970-000 Rev M
3.5 Battery
3.5 Battery
NOTE: If you purchased a spare battery, this section applies to it also.
Storage Requirements
If the battery needs to be stored, the manufacturer recommends:
ll One month: +5 to 45°C
ll One year: 20 to 25°C
The battery should start storage fully-charged. If storing the battery for an extended period,
recharge the battery periodically to avoid total discharge, which would damage the battery.
Fully recharging a battery every six months is sufficient to keep it charged enough to avoid
damage.
Always store batteries upright.
Maintenance
Every six months:
l Inspect the battery for damage or leaks
l Place the battery on a charger and allow to fully balance (battery shows all solid LEDs
when fully balanced). Fully recharging a battery every six months is sufficient to keep it
charged enough to avoid damage.
3.6 Installing the Battery
Your platform comes fully-assembled, less the battery.
NOTE: Air shipping regulations require that the battery be shipped separately.
Removing the Battery Door Skin
Accessing the battery compartment requires removing the platform's rear battery skin, which is
held in place with magnets.
!
CAUTION: PINCHRISK
The magnets holding the skin in place are strong enough to pinch you if you
are not careful.
No tools are needed for either the removal or installation of the battery door skin.
NOTE: After removing the skin, place it inner-side down, so the outer surface
doesn't get scratched.