Chapter 8: Maintenance
Figure 8-9. Docking Station Rear Cover Screws (8 of 10)
Retain the screws for reassembly.
2.
Remove the rear cover of the docking station.
3.
Locate the in-line fuse.
It will be near the top of the docking station, just to the right of the central terminal bar.
4.
Remove the old fuse, and replace it with a new fuse.
The fuse is P/N 13091-000.
5.
Reinstall the docking station rear cover, and secure with the ten screws previously
removed.
Rear Sonar Units
The platform's four rear sonar units can be replaced individually. All four sonar units are
identical, although two are used as emitters and two as receivers, in pairs.
11970-000 Rev M LD-60/90 Platform User's Manual 139
To Next Page
Loading...
