Omron LD-90 - Page 59

Chapter 4: Configuration
Access the SetNetGo OS through the MobilePlanner software:
MobilePlanner >SetNetGo >Networking
NOTE: You can use a web browser to connect directly to the SetNetGo OSon a
platform. This allows your IT support to set up the network for you, without
using MobilePlanner which requires a license.
IP Address, Netmask, Gateway, DNS1
Choose Static (DHCP is not recommended), and fill in the IP address, netmask, gateway, and
DNS1, as supplied by your network administrator.
NOTE: See your IT department for the following settings.
Radio Settings
l
SSID (e.g. AGV)
Fill in the appropriate wireless SSID for your wireless network.
The SSID is case sensitive.
l
Mode
Managed/STA, Ad-Hoc, or Master/AP
l
Radio Mode
Auto, 802.11a, 802.11b, 802.11g, 802.11n, 802.11ac
l
Channel Set
l
Wireless Watchdog IP Address
l
Wireless Watchdog Max Count
0 disables this.
Security Settings
Encryption:
l
Disabled
l
WEP 64-bit
l
WEP 128-bit
l
TKIP/RC4
l
CCMP/AES
l
TKIP/CCMP/AES
Authentication:
l
OPEN
l
WPA-PSK
11970-000 Rev M LD-60/90 Platform User's Manual 59