Omron NX701-1 - Page 394

10 Sample Programming
10-88
NJ/NX-series CPU Unit Motion Control User’s Manual (W507)
WRITE2(
Target := MC_Axis000,
SettingValue := Write2_Sv,
Execute := Write2_Ex,
ParameterNumber := Write2_Pn,
Done => Write2_D,
Busy => Write2_Bsy,
CommandAborted => Write2_Ca,
Error => Write2_Err,
ErrorID => Write2_ErrID
);
WRITE3(
Target := MC_Axis000,
SettingValue := Write3_Sv,
Execute := Write3_Ex,
ParameterNumber := Write3_Pn,
Done => Write3_D,
Busy => Write3_Bsy,
CommandAborted => Write3_Ca,
Error => Write3_Err,
ErrorID => Write3_ErrID
);