Omron NX701-1

3-27
3 Configuring Axes and Axes Groups
NJ/NX-series CPU Unit Motion Control User’s Manual (W507)
3-4 Setting Procedures for Axes Groups
3
3-4-2 Setting Procedure
1 Right-click an axes group in the Multiview Explorer and select Edit from the menu.
The Axes Group Basic Settings are displayed in the Axes Group Parameter Settings Tab Page.
2 Select from Primary periodic task or Priority-5 periodic task from Motion Control.
Additional Information
The setting is available for the NX701 CPU Unit.
Setting Axes Group Parameters