EasyManuals Logo

Omron Varispeed E7 User Manual

Omron Varispeed E7
321 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #145 background imageLoading...
Page #145 background image
5-38
Multi-function Selections: o2
Param-
eter
Number
Name Description
Setting
Range
Factory
Setting
Change
during
Opera-
tion
Access
Level
MEMO-
BUS
Register
Page
o2-01
LOCAL/
REMOTE key
enable/disable
*1
Enables/disables the LOCAL/
REMOTE key
0:Disabled
1:Enabled (Switches between the
Digital Operator and the param-
eter settings b1-01, b1-02.)
0 or 1 1 No A 505H 6-112
o2-02
STOP key during
control circuit
terminal opera-
tion
*1
Enables/disables the STOP key
0:Disabled (When the run com-
mand is issued from an external
terminal, the Stop key is dis-
abled.)
1:Enabled (Effective even during
run.)
0 or 1 1 No A 506H 6-112
o2-03
User parameter
initial value
Clears or stores user initial values.
0:Stored/not set
1:Begins storing
(Records the set parameters as
user initial values.)
2:Clearing memory (Clears all
recorded user initial values)
When the set parameters are
recorded as user initial values,
1110 can be set in A1-03 to recall
them.
0 to 2 0 No A 507H 6-112
o2-04 kVA selection
Do not set unless after replacing
the control board. (Refer to
page 5-
47
for the setting values)
0 to FF
0
*2
No A 508H 5-47
o2-05
Frequency refer-
ence setting
method selection
When the frequency reference is
set on the Digital Operator fre-
quency reference monitor, sets
whether the Enter key is necessary
or not.
0:Enter key needed
1:Enter key not needed
0 or 1 0 No A 509H 6-112
o2-06
Operation selec-
tion when digital
operator is dis-
connected
Sets the operation when the Digital
Operator is disconnected.
0:Disabled (Operation continues
even if the Digital Operator is
disconnected.)
1:Enabled (OPR is detected at
Digital Operator disconnection.
Inverter output is switched off,
and fault relay is operated.)
0 or 1 0 No A 50AH 6-112
o2-07
Cumulative oper-
ation time setting
Sets the cumulative operation time.
The operation time is accumulated
form the set value.
0 to
65535
0 hrs No A 50BH 6-112
o2-08
Cumulative oper-
ation time selec-
tion
0:Accumulated Inverter power on
time
1:Accumulated Inverter run time.
0 or 1 1 No A 50CH 6-112
o2-09 Initialize Mode
2: Europe Spec.
5: PV-E Spec.
6: Chinese Spec.
2, 5, 6 2 No A 50DH -

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Omron Varispeed E7 and is the answer not in the manual?

Omron Varispeed E7 Specifications

General IconGeneral
BrandOmron
ModelVarispeed E7
CategoryInverter
LanguageEnglish

Related product manuals