Omron Varispeed E7

10-10
L4-02 Speed agreement detection width 2.0 Hz
L4-05 Operation when frequency reference is missing 1
L4-06 Frequency reference value at frequency reference loss 80%
L5-01 Number of auto restart attempts 0
L5-02 Auto restart operation selection 0
L5-03 Fault Retry Time 10.0 sec.
L6-01 Load detection selection 6
L6-02 Load detection level 15%
L6-03 Load detection time 10.0 sec.
L8-02 Overheat pre-alarm level
95 °C
*2
L8-03 Operation selection after overheat pre-alarm 4
L8-06 Input phase loss detection level
5.0 %
*2
L8-09 Ground fault protection selection 1
L8-10 Cooling fan control selection 0
L8-11 Cooling fan control delay time 300 sec.
L8-12 Ambient temperature 45 °C
L8-15 OL2 characteristics selection at low speeds 1
L8-18 Soft CLA selection 1
L8-19 Frequency reference during OH pre-alarm 20.0%
L8-32 OH1 detection selection for fan failure 1
n1-01 Hunting prevention function selection 1
n1-02 Hunting prevention gain 1.00
n3-01 High slip braking deceleration frequency width 5%
n3-02 High slip braking current limit 150%
n3-03 High slip braking stop dwell time 1.0 sec.
n3-04 High slip braking OL7 time 40 sec.
o1-01 Monitor selection 6
o1-02 Monitor selection after power up 1
o1-03 Digital operator display scaling 0
o1-05 LCD Focus 3
o1-06
Monitor mode Selection
0
o1-07
2nd monitor selection
2
o1-08
3rd monitor selection
3
o1-09 Frequency reference display unit selection 0
o2-01 LOCAL/REMOTE key enable/disable 1
o2-02 STOP key during control circuit terminal operation 1
o2-03 User parameter initial value 0
o2-04 kVA selection
0
*2
o2-05 Frequency reference setting method selection 0
o2-06 Operation selection when digital operator is disconnected 0
o2-07 Cumulative operation time setting 0 hrs.
o2-08 Cumulative operation time selection 1
o2-09 Initialize mode 2
No. Name
Factory
Setting
Setting