F/T Zero
The F/T Zero command can be used to zero the force/torque values.
This command has no return value.
F/T Guard
Every UR commands that are put under the F/T Guard will be executed, but the robot will
stop once one of the set limits is reached. The force limiting can be mixed with an external I/O
signal (e.g.: stop if Fz>5 AND digital_in[7] == True).
NOTE:
To cancel any force/torque oset, execute an F/T Zero at the beginning of the
F/T Guard command and make sure the tool is not in contact with any object
before starting the F/T Guard, otherwise the command may not stop at the
given force/torque limit.
OPERATION
77
To Next Page
Loading...
