Install a Memory Riser
Use a T15 Torx driver to tighten the captive screws.
4.
Install any remaining DIMMs in the memory riser slots.
See “Install a DIMM” on page 96.
5.
Return the Server to Operation.
Related Information
■
“Memory Riser and DIMM Configuration” on page 83
■
“Checking DIMM Compatibility” on page 84
■
“Remove a Memory Riser” on page 91
■
“Remove a DIMM” on page 95
■
“Install a Memory Riser” on page 99
■
“Enable and Verify a DIMM” on page 103
102 SPARC T8-1 Server Service Manual • January 2022
To Next Page
Loading...
