Oracle SPARC T8-1 - Verify the Drive Backplane

Verify the Drive Backplane
a.
Reconnect the auxiliary signal cable to the drive backplane (panel 3).
b.
Reconnect the power cable to the drive backplane (panel 5).
c.
If present, reconnect the two optional NVMe cables to the storage drive
backplane (panel 5).
d.
Reconnect the two SAS cables to the drive backplane from the motherboard
(panel 6).
4.
Return the Server to Operation.
5.
“Verify the Drive Backplane” on page 151.
Related Information
■
“Internal Component Locations” on page 14
■
“Remove the Drive Backplane” on page 147
Verify the Drive Backplane
1.
Use the Oracle ILOM show faulty command to verify that the fault has been
cleared.
See “Identify Faulted Components” on page 23 for more information on using the show faulty
command.
2.
Perform one of the following tasks based on your verification results:
■ If the previous steps did not clear the fault, see “Detecting and Managing
Faults” on page 21 for information about the tools and methods you can use
to diagnose component faults.
■ If the previous steps indicate that no faults have been detected, then the
component has been replaced successfully. No further action is required.
Related Information
■
“Remove the Drive Backplane” on page 147
■
“Install the Drive Backplane” on page 149
Servicing the Drive Backplane 151