Release the CMA
Release the CMA
For some service procedures, such as replacing a power supply, if you are using a CMA, you
might need to release the CMA to gain access to the rear of the chassis.
Note - For instructions on how to install the CMA for the first time, refer to “Prepare the CMA
for Installation” in SPARC T8-1 Server Installation Guide.
1.
Press and hold the tab.
The tab is on the inside rear of the left side of the CMA.
2.
Swing the CMA out of the way.
Do not allow the CMA to hang unsupported while it is unattached.
Preparing for Service 51
To Next Page
Loading...
