Replace the Top Cover
Replace the Top Cover
1.
Place the top cover on the chassis.
Set the cover down so that it is about 1 inch (2.5 cm) forward of the rear of the server.
2.
Slide the top cover toward the rear of the chassis until the rear cover lip engages
with the rear of the chassis.
When the top cover is seated, the green button clicks into place.
Related Information
■
“Remove the Top Cover” on page 53
■
“Return the Server to the Normal Operating Position” on page 158
Returning the Server to Operation 157
To Next Page
Loading...
Need help?
General