Oracle SPARC T8-1 User Manual

Disconnect Power Cords
Disconnect Power Cords
Remove the power cords from the server only after powering off the server.
Unplug all power cords from the server.
Caution - Because 3.3V standby power is always present in the server, you must unplug the
power cords before accessing any cold-serviceable components.
Related Information
■
“Safety Information” on page 39
■
“Power Off the Server (Oracle ILOM)” on page 46
■
“Power Off the Server (Server Power Button - Graceful)” on page 47
■
“Power Off the Server (Emergency Shutdown)” on page 47
■
“Rear Panel Components” on page 13
Accessing Server Components
These topics explain how to access components on the outside and the inside of the server.
Perform these tasks in this order, as needed.
■
“Prevent ESD Damage” on page 49
■
“Extend the Server to the Service Position” on page 49
■
“Release the CMA” on page 51
■
“Remove the Server From the Rack” on page 52
■
“Remove the Top Cover” on page 53
■
“Open and Remove the Airflow Cover” on page 54
■
“Remove the Fan Cover” on page 55
Related Information
■
“Safety Information” on page 39
48 SPARC T8-1 Server Service Manual • January 2022

Oracle SPARC T8-1 Specifications

General

Brand	Oracle
Model	SPARC T8-1
Category	Server
Language	English