Remove a Memory Riser
You can perform this procedure, but the system must first be completely powered down and all
power cords unplugged. See “Component Service Categories” on page 43 for more information
about cold-service procedures.
Perform this procedure to replace a faulty memory riser or to access the DIMMs on the
motherboard below a memory riser.
1.
Prepare the system for service.
See “Preparing for Service” on page 39.
2.
Loosen the four screws that attach the memory riser to the standoffs.
Use a T15 Torx driver to loosen the captive screws.
92 SPARC T8-1 Server Service Manual • January 2022
To Next Page
Loading...
