Restore a Saved Oracle ILOM Firmware Configuration (Oracle ILOM)
Backing Up and Restoring Hardware and Firmware Configurations 107
■
host is the IP address or hostname of the system where the backup file is saved.
■
filepath is the relative path to the backup file.
Note - If you transfer the backup file using TFTP, you do not need to provide a username or
password.
Related Information
■
Restore BIOS Configuration, Oracle ILOM Administrator's Guide for Configuration and
Maintenance, Firmware Release 3.2.x at http://www.oracle.com/goto/ilom/docs
Restore a Saved Oracle ILOM Firmware
Configuration (Oracle ILOM)
Before you begin, ensure that you have the privileges associated with the following roles in
Oracle ILOM: Admin (a), User Management (u), Console (c), and Reset and Host Control (r).
1.
To restore a saved Oracle ILOM configuration from the Oracle ILOM web
interface, perform the following steps:
a.
Log in to the Oracle ILOM web interface.
For instructions, see “Accessing Oracle ILOM” on page 21.
b.
In the navigation pane, click ILOM Administration > Configuration
Management.
c.
Select Restore in the Operation drop-down list.
d.
In the Transfer Method drop-down list, select a transfer method.
e.
Specify the location of the XML file.
f.
If you specified a Passphrase when you exported the XML file, enter and
confirm the Passphrase.
Note - With Oracle ILOM 3.2.6 or newer, if you included fault data in the backup, you can
select Include Fault Data to restore it. This selection is reserved for Oracle service personnel
when they replace the SP. It requires a passphrase.
g.
Click Run.
To Next Page
Loading...
Need help?
General
