Oracle X6 series User Manual

Reset the Oracle ILOM Firmware to Default Settings (Oracle ILOM)
112 Oracle X6 Series Servers Administration Guide • April 2016
Related Information
■
Updating the UEFI BIOS (ubiosconfig), Oracle Server CLI Tools User's Guide at http://
www.oracle.com/goto/ohmp/docs
Reset the Oracle ILOM Firmware to Default
Settings (Oracle ILOM)
1.
To reset the Oracle ILOM firmware to default settings in the Oracle ILOM web
interface, perform the following steps:
a.
Log in to the Oracle ILOM web interface.
For instructions, see “Accessing Oracle ILOM” on page 21.
b.
In the navigation pane, click ILOM Administration > Configuration
Management, and then click the Reset Defaults tab.
c.
In the Reset Defaults drop-down list, select Factory.
d.
Click Reset Defaults.
2.
To reset the Oracle ILOM firmware to default settings in the Oracle ILOM
command-line interface (CLI), perform the following steps:
a.
Log in to the Oracle ILOM CLI.
For instructions, see “Accessing Oracle ILOM” on page 21.
b.
Type set /SP reset_to_defaults=factoryset.
Related Information
■
Reset the Oracle ILOM Configuration to Factory Defaults, Oracle ILOM Administrator's
Guide for Configuration and Maintenance, Firmware Release 3.2.x at http://www.oracle.
com/goto/ilom/docs
Reset the Oracle ILOM Firmware to Default
Settings (Oracle Hardware Management Pack)
1.
Access the operating system command-line interface.

Oracle X6 series Specifications

General

Cores per Processor	Up to 22 cores
Processor	Intel Xeon E5-2600 v4 series
Networking	10GbE
Form Factor	Rackmount
Expansion Slots	PCIe slots available
Power Supply	Redundant power supplies
Storage	supports SAS, SATA, and NVMe drives