Oracle X6 series User Manual

Configure a Host Storage Device Redirection Session
30 Oracle X6 Series Servers Administration Guide • April 2016
d.
Enter the location of the image on the remote server using either the NFS or
Samba protocol.
■
To enter a URI using NFS, use the format: nfs://server:/path/file
For example:
nfs://198.51.100.2:/export/netadmin1/biosimage.img
■
To enter a URI using Samba, use the format: smb://server:/path/file or
smb://server/path/file.
For example:
smb://198.51.100.2/netadmin1/biosimage.img
e.
Click Save.
The status of the redirection appears in the Status field.
f.
When you are done, to disable redirection, select Disabled from the Mode
drop down menu and click Save.
2.
To configure a host storage device redirection in the Oracle ILOM command-line
interface (CLI), perform the following steps:
a.
Log in to the Oracle ILOM CLI.
For instructions, see “Accessing Oracle ILOM” on page 21.
b.
Set the location of the image file by typing:
set /SP/services/kvms/host_storage_device/remote/
server_URI=NFS_or_Samba_URI_file_location [username=username]
[password=password]
c.
Enable storage redirection by typing:
set /SP/services/kvms/host_storage_device/ mode=remote
d.
To view the status of redirection, type the command:
show /SP/services/kvms/host_storage_device/ status
Note - Redirection is active is the status if set to either Operational or Connecting.
e.
When you are done, disable redirection by typing:

Oracle X6 series Specifications

General

Cores per Processor	Up to 22 cores
Processor	Intel Xeon E5-2600 v4 series
Networking	10GbE
Form Factor	Rackmount
Expansion Slots	PCIe slots available
Power Supply	Redundant power supplies
Storage	supports SAS, SATA, and NVMe drives