Oracle X6 series - Page 44

Set SP Host Power Policy at Boot
44 Oracle X6 Series Servers Administration Guide • April 2016
d.
In the Actions drop-down list, select Enable.
2.
To set a power-on policy in the Oracle ILOM command-line interface (CLI),
perform the following steps:
a.
Log in to the Oracle ILOM CLI.
For instructions, see “Accessing Oracle ILOM” on page 21.
b.
Use one of the following commands:
■
set /SP/policy HOST_AUTO_POWER_ON=enabled
■
set /SP/policy HOST_LAST_POWER_STATE=enabled
The power-on policies are mutually exclusive, that is, only one can be enabled at a time.
For more information about each policy, see the Related Information section following this
procedure.
Related Information
■
Power-On and Cooling-Down Policies Configurable from the Server SP, Oracle ILOM
Administrator's Guide for Configuration and Maintenance, Firmware Release 3.2.x