Oracle X7-2 Installation Guide

Configure RAID Using the Avago MegaRAID Configuration Utilities
13.
Select Confirm, select Enabled, and press Enter.
14.
To save your new boot configuration, select Yes.
15.
To exit the Avago MegaRAID Utility, press the ESC.
Rapid Storage Technology Enterprise (RSTe)
You can create and manage RAID arrays on the Oracle Servers X7-2 and X7-2L SATA M.2
(SSDs) using Intel Rapid Storage Technology Enterprise (RSTe) which provides the following
benefits:
■
Additional protection from data loss.
■
Data is protected against a drive failure when you configure your system for RAID level 1
(mirror).
■
Additional advantage of allowing an operating system to install directly to the RAID
volume.
■
BIOS exports the volumes as a target device to the operating system installer, streamlining
the OS installation.
■
The OS uses the system CPUs to manage and configure the RAID volumes.
Configuring Storage Drives for Operating System Installation 107

Oracle X7-2 Specifications

General

Processor	Intel Xeon Scalable processors
Number of Processors	1 or 2
Memory	Up to 1.5 TB DDR4
Memory Slots	24 DIMM slots
Form Factor	2U Rackmount
Storage Bays	8 x 2.5-inch
CPU Socket	Socket P (LGA 3647)
Power Supply	Redundant hot-swappable power supplies