Oracle X7-2 - Access Serial Remote Host Console

Access Serial Remote Host Console
5.
To exit the Oracle ILOM Remote System Console Plus, click Exit in the KVMS
menu.
For more information about using the Oracle ILOM Remote System Console Plus, refer to the
Oracle ILOM Administrator's Guide for Configuration and Maintenance, Firmware Release 4.x
at http://www.oracle.com/goto/ilom/docs.
Access Serial Remote Host Console
Before you begin, you can configure properties in Oracle ILOM to make the serial host
console easier to view and to enable logging. For more information, refer to the Oracle ILOM
Administrator's Guide for Configuration and Maintenance, Firmware Release 4.0.x at http://
www.oracle.com/goto/ilom/docs.
This procedure describes how to access the host console remotely. To connect to the host
console locally, see “Log In to Oracle ILOM Using a Local Serial Connection” on page 85.
1.
Log in to the Oracle ILOM CLI using an account with Administrator privileges.
For instructions, see “Log In to Oracle ILOM Using a Remote Ethernet
Connection” on page 86.
2.
At the Oracle ILOM command prompt (->), type: start /HOST/console
The serial console output appears on the screen.
Note - If the serial console is in use, stop and restart it using the stop /HOST/console
command followed by the start /HOST/console command.
3.
To return to the Oracle ILOM console, press Esc and then press Shift + 9 to enter
the open parenthesis ( character.
96 Oracle Servers X7-2 and X7-2L Installation Guide • October 2017