Oracle X7-2 - Controlling System Power; Powering the Host on and off

Controlling System Power
This section describes how to power on, power off, and reset the server.
■
“Powering the Host On and Off” on page 119
■
“Resetting the Server” on page 122
Related Information
■
“Installation Procedure Overview” on page 11
■
Oracle Integrated Lights Out Manager (ILOM) Documentation Library at: http://www.
oracle.com/goto/ilom/docs
Powering the Host On and Off
Your server has three power modes (states): power off, standby power, and main power.
Power
State
Description Indicators Action
Power off The server is completely
powered off when the
AC power cords are
disconnected.
All indicators are off.
The server is disconnected
from all power sources.
Disconnect power cords to completely
remove power.
Caution - Electrical Hazard. Equipment
damage. Do not disconnect power cords
when the system is in Main power mode.
Standby
power
When the server is in
Standby power mode,
the service processor is
powered on but the host is
powered off.
The green System OK
indicator blinks slowly.
The green SP OK indicator
is steady on.
If the server is completely powered off,
plug in the power cords to apply Standby
power.
If the server is in Main power mode, use
Oracle ILOM or the Power button to
remove host power.
You can power the host off gracefully, or
immediately.
Controlling System Power 119