Oracle X7-2 - Power off the Host Using the Power Button

Power Off the Host Using the Power Button
Power
State
Description Indicators Action
Caution - Data loss. To prevent data
loss, prepare the operating system for
shutdown before you immediately power
off.
Main power When you power on the
host, the server enters
Main power mode.
The green System OK
indicator is steady on.
Use Oracle ILOM or the Power button to
apply host power.
For instructions on powering the host off and on, see the following procedures:
■
“Power Off the Host Using the Power Button” on page 120
■
“Power On the Host Using the Power Button” on page 121
■
“Power the Host On and Off Using Oracle ILOM” on page 121
Power Off the Host Using the Power Button
1.
Locate the Power button on the server front panel.
2.
Press the Power button.
■ To perform a graceful shutdown, press and release the Power button.
ACPI-enabled operating systems perform an orderly shutdown. Operating systems that are
not ACPI-enabled might ignore this event and fail to shut down the host.
The System OK indicator blinks. The service processor SP OK indicator is steady on.
■ To perform an immediate shutdown, press and hold the Power button for at
least 5 seconds.
The System OK indicator blinks. The service processor SP OK indicator is steady on.
Caution - Data loss. An immediate shutdown abruptly closes all applications and files without
saving changes.
■ To completely power off the server, disconnect the power cords from the
back panel of the server.
120 Oracle Servers X7-2 and X7-2L Installation Guide • October 2017