Agency Compliance
Circuit Breaker and UPS Guidelines
To prevent failures:
■
Ensure the design of your power system provides adequate power to the server.
■
Use dedicated AC breaker panels for all power circuits that supply power to the server.
■
Ensure that electrical work and installations comply with applicable local, state, or national
electrical codes.
■
Ensure the electrical circuits are grounded.
■
Provide a stable power source, such as an uninterruptable power supply (UPS) to reduce
the possibility of component failures. If computer equipment is subjected to repeated power
interruptions and fluctuations, then it is susceptible to a higher rate of component failure.
Grounding Guidelines
Use the following guidelines for grounding the server:
■
Always connect the cords to grounded power outlets.
■
Because different grounding methods are used, depending on location, verify the grounding
type. For the correct grounding method, refer to local electrical codes.
■
Ensure that a facility administrator or qualified electrical engineer verifies the grounding
method for the building and performs the grounding work.
Agency Compliance
The server complies with the following specifications.
Category Relevant Standards
Regulations
†,‡
■ Product Safety: UL/CSA 60950-1, EN 60950-1, IEC
60950-1 CB Scheme with all country differences
■ EMC
■ EMC: Emissions: FCC 47 CFR 15, ICES-003,
EN55022, EN55032, KN32, EN61000-3-2,
EN61000-3-3
■ Immunity: EN 55024, KN35
20 Oracle Servers X7-2 and X7-2L Installation Guide • October 2017
To Next Page
Loading...
Need help?
General
