Oracle X7-2 - Install AC Power Cables and Slide-Rails

Install AC Power Cables and Slide-Rails
2.
Place the Rackmounting Template against the front rails, aligning the bottom
edge of the card with the bottom edge of the server, and measure up from the
bottom of the Rackmounting Template.
3.
Mark the mounting holes for the front slide-rails.
4.
Mark the mounting holes for the back slide-rails.
Related Information
■
“Rack Compatibility” on page 41
■
“Install Mounting Brackets on the Server” on page 44
■
“Attach the Slide-Rails” on page 49
Install AC Power Cables and Slide-Rails
1.
Before you install the slide-rails into the rack, install right-angle AC power
cables into the left-side and right-side PDU electrical sockets.
Use the following 2-meter right-angle AC power cable for this procedure:
Installing the Server Into a Rack 47