Install Mounting Brackets on the Server
1.
Position a mounting bracket against the chassis so that the slide-rail lock is
at the server front, and the five keyhole openings on the mounting bracket are
aligned with the five locating pins on the side of the chassis.
Callout Description
1 Chassis front
2 Slide-rail lock
3 Mounting bracket
4 Mounting bracket clip
2.
When the heads of the five chassis locating pins protrude through the five
keyhole openings in the mounting bracket, pull the mounting bracket toward
the front of the chassis until the mounting bracket clip locks into place with an
audible click.
3.
Verify that the back locating pin is engaged with the mounting bracket clip.
Installing the Server Into a Rack 45
To Next Page
Loading...
