Remove the Cable Management Arm
e.
Remove the cables from the CMA and set them aside.
4.
To disconnect connector D:
a.
Press the green release tab (callout 1) on the slide-rail latching bracket
toward the left and slide the connector D out of the left slide-rail [frames 1
and 2].
When you slide connector D out of the left slide-rail, the slide-rail latching bracket portion
of the connector remains in place. You will disconnect it in the next step.
Note - After you disconnect connector D, do not allow the CMA to hang under its own weight.
Throughout the remainder of this procedure, the CMA must be supported until all the remaining
connectors are disconnected and the CMA can be placed on a flat surface.
66 Oracle Servers X7-2 and X7-2L Installation Guide • October 2017
To Next Page
Loading...
