range Pi 用户手册 深圳市迅龙软件有限公司版权所有
www.orangepi.cn 137 www.xunlong.tv
b. The Linux distributions supported by linxu3.4 are as follows
6) Then select the type of image
a. Image with console interface represents the image of the server version, which
is relatively small
b. Image with desktop environment indicates that the image of desktop version
and the volume is relatively large
7) If it is to compile the image of the server version, you can also choose to compile the
Standard version or the Minimal version. The pre-installed software of the Minimal
version will be much less than the Standard version.
8) After selecting the type of image, it will start to compile the Linux image. The general
process of compiling the image is as follows
a. Compile u-boot source code and generate u-boot deb package
b. Compile linux source code, generate linux related deb package
c. Make deb package of linux firmware
d. Make deb package of orangepi-config tool
e. Make board-level support deb package
f. If it is to compile the desktop version image, the desktop related deb package
will also be made
g. Check whether the rootfs has been cached, if there is no cache, re-create the
rootfs, if it has been cached, just unzip and use
h. Install the previously generated deb package into rootfs
i. Make some specific settings for different development boards and different types
To Next Page
Loading...
