Oshkosh M1070 - Page 502

DECISION
No - Turn CTIS switch to ON position. (WP 0028)Test 5 - Does CTIS operate
properly?
Yes - Test 2 - Does CTIS run properly after resetting controller?
TEST 2 - Does CTIS run properly after resetting controller?
NOTE
Turning CTIS OFF, and then ON, resets controller.
1. Set CTIS ON/OFF switch (WP 0028) to OFF position.
NOTE
CTIS will not operate if air system pressure is less than 85 psi (586 kPa).
2. Turn ON CTIS. (WP 0028)
CROSS COUNTRY
HIGHWAY
MUD SAND & SNOW
9 MAX SPEED 45 MPH)
(MAX SPEED 30 MPH)
( MAX SPEED 15 MPH)
( MAX SPEED 5 MPH)
EMERGENCY
OVERSPEED
LOW AIR
START
CTI OFF - ON
CTI CONTROLLER MODEL 101
CTIS CONTROLS
BLACK
OUT
DRIVE
BLACK
OUT
MARKER
BLACK
OUT
LIGHTS
CHECK
GAUGES
CHECK
ENGINE
AIR
LOW
CROSS COUNTRY
HIGHWAY
MUD SAND & SNOW
9 MAX SPEED 45 MPH)
(MAX SPEED 30 MPH)
( MAX SPEED 15 MPH)
( MAX SPEED 5 MPH)
EMERGENCY
OVERSPEED
LOW AIR
START
CTI OFF - ON
CTI CONTROLLER MODEL 101
TRAILER
AIR SUPPLY
ENGINE
OFF
ON
START
FILTER MINDER
AIR CLEANER RESTRICTION
RESET
H O
2
—20—
—15—
—10—
— 8 —
PARKING
BRAKE
INSTRUMENT PANEL W/ TACHOGRAPH SHOWN,
INSTRUMENT PANEL W/ SPEEDOMETER & TACHOMETER SIMILAR
Figure 2. CTIS Controls.
3. Check CTIS operation. (WP 0028)
CONDITION/INDICATION
Does CTIS run properly after resetting controller?
DECISION
No - Test 3 - Is CTIS circuit breaker tripped?
Yes - Problem corrected.
TEST 3 - Is CTIS circuit breaker tripped?
1. Check if CTIS circuit breaker has been tripped.
TM 9-2320-360-10 0092
0092-2