SAFETY, CARE, AND HANDLING - Continued
Table 4. Significant Hazards And Safety Recommendations. - Continued
OPERATING HAZARD
SAFETY RECOMMENDATION OR
PRECAUTION
CONDITION
(see NOTE
below)
Winching operations Do not use winches (WP 0035) for lifting
personnel. Always wear heavy gloves
when handling winch cable. Never let
cable run through hands. Frayed cable
can cut severely. Do not operate winch
without guard in place. Do not place
hands or feet near winch during
operation. Ensure that both DRIVER
SIDE and PASSENGER SIDE WINCH
KICKOUT controls are disengaged prior
to paying out winch cables. Failure to
disengage KICKOUT controls may
result in injury to personnel.
Normal
NOTE
Category of hazards as to whether or not they may be expected under
normal or abnormal operating conditions.
METRIC SYSTEM
The equipment described herein contains metric components and requires metric, common,
and special tools. Therefore, metric units and English units will be used throughout this
publication. A chart is supplied below to help convert these measurements.
LINEAR MEASURE
1 Centimeter = 10 Millimeters = 0.01 Meters = 0.3937 Inches
1 Meter = 100 Centimeters = 1000 Millimeters = 39.37 Inches
1 Kilometer = 1000 Meters = 0.621 miles
SQUARE MEASURE
1 Sq Centimeter = 100 Sq Millimeter = 0.155 Sq Inches
1 Sq Meter = 10,000 Sq Centimeter = 10.76 Sq Feet
1 Sq Kilometer = 1,000,00 Sq Meters = 0.386 Sq Miles
WEIGHTS
1 Gram = 0.001 Kilograms = 1000 Milligrams = 0.035 Ounces
TM 9-2320-360-10 0001
0001-12
To Next Page
Loading...
