Pakedge MS Series User Manual

MS Series User Guide
44
Configuring IGMP Snooping Querier
To access the IGMP Snooping Querier configuration menu:
1. Click the switch’s Advanced tab, then click the IGMP Snooping tile.
The IGMP Snooping Querier Configuration screen opens.
Field
Description
Admin Mode
When enabled, the IGMP snooping querier sends out periodic IGMP
queries that trigger IGMP report messages from the switches that
want to receive IP multicast traffic. IGMP snooping listens to these
IGMP reports to establish appropriate forwarding.
IP Address
The snooping querier address to be used as source address in
periodic IGMP queries. This address is used when no IP address is
configured on the VLAN on which the query is being sent. The
default entry to allow the switch to use its own IP address is 0.0.0.0.
IGMP Version
The IGMP protocol version used in periodic IGMP queries.
Query Interval
(Seconds)
The amount of time the IGMP snooping querier on the device should
wait between sending periodic IGMP queries.
Querier Expiry Interval
(Seconds)
The amount of time the device remains in non-querier mode after it
has discovered that there is a multicast querier in the network.

Pakedge MS Series Specifications

General

Brand	Pakedge
Model	MS Series
Category	Switch
Language	English