Chapter 5 Using Address Book
78
To use Quick Connect from the Address list:
1. Highlight the Address entry to which you want to connect.
2. Press Command Stroke + I.
Alternately, press Function + Menu , and select Connect on the
Record menu.
3. Select the method you want to use to connect.
Quick Connect initiates the related task. For example, if you tap a phone
number, Quick Connect sends the selected phone number to your mobile
phone.
To configure Quick Connect settings:
1. From the Quick Connect dialog box, tap Settings.
2. (Optional) Tap the Number Prefix check box and enter a prefix.
For example, to dial 1 before all phone numbers, select this check box and enter
a “1” in this field. The prefix is not added to a number that begins with the “+”
character.
3. Tap each of the pick lists and select the application you want to associate with
that task.
4. Press Function + Enter
,
or tap OK.
Tap-to-Connect
With Tap-to-Connect you can select an entry and initiate a related task by tapping
it with the stylus. By default, Tap-to-Connect is not enabled.
To Next Page
Loading...
Need help?
General
