183
Conguring the Hybrid GHP/EHP control
Setting
6
Set the start time.
z Touch the text box and the operation dialogue is displayed.
Set in the range 00:00 to 23:59.
6
7
Touch [Register].
z To cancel the settings, touch [Cancel].
7
Setting cost priority control [Cost settings]
Example start time setting
Time slot settings are referenced when the current time is after the start time and before the start time set thereafter.
y You can make the settings extend over different dates.
For example: 22:00 to 08:00
y The start time is valid only for those time slots where a check mark has been put in the “Valid” column.
For example:
When set as follows;
y Put a check mark in the “Valid” column for Timeslots 1 and set the start time to
03:00.
y Put a check mark in the “Valid” column for Timeslots 2 and set the start time to
22:00.
Timeslots 2 Timeslots 1 Timeslots 2
Timeslots 1
3:00
If the current time is between 03:00 and
22:00, Timeslots 1 settings are referenced.
If the current time is between 22:00 and
03:00, Timeslots 2 settings are referenced.
Timeslots 2
22:00
To Next Page
Loading...
