Panasonic CZ-256ESMC3 - Control Operation at Regular Intervals [O;D Unit Cyclic]

102
Settings for energy saving
Energy saving
This type of control rotates through at 10 minute intervals, evenly operating the outdoor units in the
control groups either operating (or stopping) and recovering.
Attention
y Register the demand point input before making these settings. (P.89)
y Before making these settings, also cancel the demand operation settings ([No settings]) for the outdoor units in the “O/D unit information”
screen. (P.35)
3
Put a check mark in the “Select” column
(3-1), and touch [Set.] (3-2).
z The “Setting” dialogue is displayed.
3-
1
3-
2
4
Change the settings.
Item Explanation
Control Gr. 1-5
Press
to set the control group that the
outdoor unit is to be allocated to.
Set from “Gr.1” to “Gr.5”.
Demand Select an operation.
No operation is caused if you select [----].
When you have selected [Ope.], set the control
rate with
. The values shown are
those values that can be set for the outdoor unit
selected.
Continued on next page
1
Touch [Demand setting] in
“EnergySaving”.
1
2
Touch [O/D unit cyclic].
z Enter the identication number (password level 1 or 2) and
the “O/D unit cyclic” screen is displayed.
2
When using cycling control at 10 minute intervals on the
outdoor units in control groups 1 to 5
Control groups 1 and 3 are “Force stop” and control groups 2, 4 and
5 are “50%” operation, and the cycling control happens at 10 minute
intervals.
Control operation at regular intervals [O/D unit cyclic]
10 min. 10 min. 10 min. 10 min. 10 min.
Forced stop
Forced stop
Normal
operation
Normal operation
Normal operation
Normal operation
Normal operation
Normal operation
Normal
operation
50% control
50% control
50% control
Normal operation
Control group 1
Control group 2
Control group 3
Control group 4
Control group 5