160
Conguring the system
Setting
Set the distribution mode
Set the mode used for distributing when calculating charges.
There are two methods for distribution.
Time distribution: This method calculates distribution ratios based on the operating times of the indoor
units (thermostat ON cumulative time and thermostat OFF cumulative time).
Load distribution: This method calculates distribution ratios based on the electricity/gas usage (including
standby power) of the indoor units and outdoor units.
Item Explanation
Distribution
modes
Set the distribution mode (time distribution or
load distribution).
y Load distribution is not available for “Hybrid
GHP/EHP”.
GasDist/PwGn Select whether to calculate distributions when
using gas for power generation.
y When set to “No”, you cannot set charge each
area and billing method.
Charge each
area
Select whether to use charge each area for gas
power generation.
y When set to “No”, you cannot set billing
method.
Billing method Set the billing method for gas power generation.
Energy savng
dist
Set the range of energy savings effects for multi-
function air conditioners or ice thermal storage
models in calculations for distribution. (when load
distribution only)
y With “O/D system”, only the air conditioning
distribution of the area of the outdoor system
is reected.
y With “DistrGrp”, the air conditioning
distribution of all areas in the entire distribution
group is reected.
PwrDistr calc trgt Set the target of electricity distribution
calculation.
y “OpertnTime” is distributed between the
electricity for both outdoor units and indoor
units.
y “T/S ONTime” is distributed to the electricity
for only outdoor units.
4
Touch [Register].
z To cancel the settings, touch [Cancel].
4
1
Touch [System Settings] in “Settings”.
z The “System settings” screen is displayed.
1
2
Touch [Distribution mode settings].
z Enter the identication number (password level 1 or 2) and
the “Distribution mode settings” screen is displayed.
2
3
Change the settings.
To Next Page
Loading...
