65
Check accumulated values
Operation/Status
Checking the list of accumulated values on
the indoor unit
The accumulated values for indoor units (thermostat ON operating times, etc.) are displayed in a list.
1
Touch [Accumulate/Distrib] in “Oper./
Status”.
1
2
Touch [I/D unit acc.].
z The “I/D unit acc.” screen is displayed.
2
3
Set the period to be displayed.
z Set the start and end of the period to be displayed.
z The time at the left is the start of the period and the time at
the right is the end.
z If you set “Data” to “Adaptor value”, you cannot select the
period to be displayed.
(1) Touch (3-1).
z The “Calendar” dialogue is displayed showing the current
date.
3-
1
(2) Touch the date (3-2).
z Use to select the month you want to check. The
current month is displayed if you touch [ThsMth].
z The settings are registered and the “Calendar” dialogue
closes.
3-
2
4
Set the time slots to display.
(1) Touch [Time] (4-1).
z The “Specify time” dialogue is displayed.
z If you set “Data” to “Adaptor value”, you cannot select the
time slots to be displayed.
4-
1
Continued on next page
To Next Page
Loading...
