Panasonic CZ-256ESMC3 - Basic Settings for the Pulse Meter

158
Conguring the system
Setting
Basic settings for the pulse meter
Make allocations between pulse meters and distribution groups.
4
Touch [Setng].
z The “Edit pulse meter sttgs” dialogue is displayed.
4
5
Change the settings.
Item Explanation
Name Change the pulse meter name.
You can enter up to 16 letters or numbers.
UnitName Enter the units to be displayed for the pulse meter.
MultFctr
Use
to set the multiplying factor to
be displayed for the pulse meter.
After decimal
pt
Use
to set the number of decimal
places to be displayed for the pulse meter. (0 to 3)
Display
Use
to set the order when displayed
in a list.
Type
Use
to set the pulse meter type.
Select from “Elec”, “Gas”, “PwGn”, “TpWt”, and
“Ice”.
Continued on next page
1
Touch [System Settings] in “Settings”.
z The “System settings” screen is displayed.
1
2
Touch [Pulse meter settings].
z Enter the identication number (password level 2) and the
“Pulse meter settings” screen is displayed.
2
3
Put a check mark in the “Select” column.
z Select the pulse meter to be edited.
3