Panasonic CZ-256ESMC3 - Setting the Screen Display and Volume for this Unit

199
Maintenance settings
Setting
Setting the screen display and volume for this unit
You can adjust the brightness of the screen or adjust the buzzer sound.
3
Change the settings.
Item Explanation
Brgtns Adjust the brightness of the back light in 5 steps
(1 to 5).
Off time
AftrOper
If there are no screen operations after the
specied time* is exceeded, the backlight turns off
automatically and the operation is locked.
y To unlock, touch the screen and enter your
identication number (password). (P.22)
If the identication number (password) is not
set, it is not necessary to enter the identication
number (password).
y The back light does not turn off if you touch
[Invalid].
* The actual time can differ by about a minute.
CleanngMde All operations are disabled on the liquid crystal
display when you touch this [Start] so that you can
clean it.
This is cancelled when you touch [END].
Auto logout
time
Log out automatically after the specied time.
(“30 m”, “1hour”, or “12 hrs”)
Buzzr vol. You can adjust the volume of the buzzer. No sound
is output if you touch [Qiet].
4
Touch [Register].
z To cancel the settings, touch [Cancel].
4
1
Touch [IntelContrlr maint] in “Settings”.
z The “IntelContrlr maint” screen is displayed.
1
2
Touch [Display/Volume settings].
z Enter the identication number (password level 1 or 2) and
the “Display/Volume settings” screen is displayed.
2