66
Check accumulated values
Operation/Status
The “I/D unit acc.” screen
A: Set the order of display.
[Area] Display indoor units by area.
[I/D unit] Display indoor units in display
order.
B: Set the displayed values. The “Data type”
dialogue is displayed when you touch this.
Select from “Adaptor value”, “Balance total”,
or “WeighFactrBlnceTtl”.
C: Set the periods to be displayed. The
“Calendar” dialogue is displayed when you
touch this.
D: Set the time slots to be displayed. The
“Specify time” dialogue is displayed when
you touch this.
E: The accumulated values for indoor units are
displayed in a list.
You can scroll up or down by swiping or
icking the screen.
Item Explanation
Name The names of the indoor units are displayed.
Area The area number that the indoor unit belongs to is displayed.
ON/High Displays the accumulated operating hours when the thermostat is “ON” and the fan is set to “High”.
ON/Mid Displays the accumulated operating hours when the thermostat is “ON” and the fan is set to “Mid.”.
ON/Low Displays the accumulated operating hours when the thermostat is “ON” and the fan is set to “Low”.
Total T/S ON The total value of accumulated operating hours when the thermostat is “ON” and when “ON/High”, “ON/Mid”, and “ON/Low”.
OFF/High Displays the accumulated hours when the thermostat is “OFF” and the fan is set to “High”. (When [T/S OFF details] is
touched)
OFF/Mid Displays the accumulated hours when the thermostat is “OFF” and the fan is set to “Mid.”. (When [T/S OFF details] is
touched)
OFF/Low Displays the accumulated hours when the thermostat is “OFF” and the fan is set to “Low”. (When [T/S OFF details] is
touched)
Total T/S OFF Displays the accumulated hours when the thermostat is “OFF”.
Elec Htr ON Displays the accumulated hours when the heater is “ON”. (When [T/S OFF details] is touched)
T/S ON + T/S OFF Displays all the accumulated operating hours.
F: The “OFF/High ”, “OFF/Mid”, “OFF/Low”, and “Elec Htr ON” items are added to the display when you touch this. Touch again to
return to the items displayed previously.
G: You can output (save) the displayed list of indoor unit accumulation in CSV format. (→ “Outputting (saving) the displayed contents
as a CSV le” (P.32))
A
C
D
B
FG
E
5
Check accumulated values.
Checking the list of accumulated values on the indoor unit
(2) Touch the time slot to accumulate (4-2).
z The settings are registered and the “Specify time” dialogue
closes.
z Refer to “RglrHourRnge” in “Calendr sttgs for distr calc”
(P.148) for information about “Rglr hour1” to “Rglr hour8”.
4-
2
To Next Page
Loading...
