211
Maintenance settings
Setting
Item Explanation
Chattering cancel
time (msec)
Set the time until cancelling when chattering
occurs.
6
Touch [NextPage →].
z The “Settngs for communictn w A/C(3)” screen is
displayed.
z To return to the “Settngs for communictn w A/C(1)” screen,
touch [← PrevPage].
z If you touch [Cancel], all the settings up to that point are
cancelled.
7
Change the settings.
Item Explanation
AlrmLog outp Select whether to output alarm logs.
Alarm mails are not sent if the check mark is
removed.
You can select only the following checks and
alarms. Others are executed irrespective of the
setting.
y InspcnSign:
Filter sign
Engine oil check
Remote controller display check
y ComError:
C17 alarm (communication error between
the unit and the air conditioning unit)
C06 alarm (communication error between
the unit and the communication adaptor)
Local R/C Prhbt
settings
Set “Prbt1” to “Prbt4” for each item (“ON/OFF”,
“Temp. setngs”, “Mode”, “Fan SPD”, “Flap”, or
“Energy saving”) to set whether to permit or
prohibit operations and settings with the local
remote controller.
Each time you touch either “” or “” is
displayed.
y “”: Operation and setting with the local
remote controller is enabled
y “”: Operation and setting with the local
remote controller is prohibited
Touch [InitlSet] to restore the default factory
settings.
8
Touch [Register].
z All of the settings are registered.
z If you touch [Cancel], all the settings up to that point are
cancelled.
8
Setting communications with air conditioning units
To Next Page
Loading...
