Panasonic CZ-256ESMC3 - Page 27

27
Check the operation and status of air conditioning units
Operation/Status
Item Explanation
Set temp. Set the temperature.
1) Touch [Set temp.].
2)
Set the temperature with and .
(± in 1 °C steps)
<Setting ranges>
y In cooling or drying mode: Between
18 °C and 30 °C
y In heating mode: Between 16 °C and
30 °C*
1
y Automatic: Between 17 °C and 27 °C
*1 The upper limit temperature for some
models is 26 °C.
Fan SPD Set the strength of the fan.
1) Touch [Fan SPD].
2)
Select the fan speed (
(high),
(mid),
(low), (automatic)).
Flap*
2
Set the direction of the airow.
1) Touch [Flap].
2)
Set the ap to the desired position (
(F1),
(F2), (F3), (F4), (F5),
(Swing)).
Touch
during the swing to stop the ap
at the desired position.
y Heating, fan, and automatic (heating)
can be adjusted in 5 steps and cooling
and dry can be adjusted in 3 steps.
y You can set either
or if the
model does not support airow direction
settings.
Prohibitn.*
3
Set whether to allow or prohibit use of the local
remote controller.
1) Touch [Prohibitn.].
2)
Use
to select from “Accept”,
“Prhbt1”, “Prhbt2”, “Prhbt3”, or “Prhbt4”.
Accept: Allows operations with the remote
controller.
Prhbt1 to Prhbt4: Operations on the
remote controller are restricted. You can
change the restricted operations. (P.211)
Eco Enable or disable energy saving operation.
1) Touch [Eco].
2) Select “Valid” or “Invl”.
Enable or disable ECONAVI setting.
1)
Touch
.
2) Select “Valid” or “Invl”.
*2 The air ow indicated on the Intelligent Controller is different from
the actual angle.
*3 Example of prohibiting or enabling remote controller use (factory
setting)
ON/OFF Mode Set temp.
Fan
SPD
Flap Eco
Accept
     
Prhbt1
     
Prhbt2
     
Prhbt3
     
Prhbt4
     
: Operation and setting with the remote controller is possible
: Operation and setting with the remote controller is not possible
6
Touch [Transmit].
z The settings are registered and the “Settings” dialogue
closes.
z To cancel the settings, touch [Cancel].
6
Note
y Touch (or ) at the upper value (or lower value) of the
set temperature and the set value becomes a blank (no setting).
Make the setting blank when you want no setting.
Furthermore, touch (or ) and the upper value (or lower
value) is displayed.
For example:
If upper value 30 °C and
lower value 18 °C (cooling)
19 °C
18 °C (lower limit value)
(blank)
30 °C (upper limit value)
29 °C
Operating the indoor unit