75
Checking distribution data
Operation/Status
The “Distribution data” screen
A: Set the units of display.
[Area] Display indoor units by area.
[I/D unit] Display indoor units in display
order.
B: Set the periods to be displayed. The
“Calendar” dialogue is displayed when you
touch this.
C: Set the time slots to be displayed. The
“Specify time” dialogue is displayed when
you touch this.
D: Indoor unit distribution data is displayed in
a list.
Item Explanation
Name The names of the indoor units are displayed.
Subt This is the subtotal of the specied unit.
Area The area number that the indoor unit belongs to is displayed.
Dstr The distribution group number is displayed.
Elec. ratio (%) This is the distribution ratio of electricity supplied from outdoor units.
Elec. usage (kWh) This is the usage of electricity supplied from outdoor units.
Elec. cost This is the charges calculated based on the electricity usage.
O/D Gas ratio(%) This is the distribution ratio of gas supplied from GHP.
O/D Gas usage(m3) This is the quantity of gas supplied from GHP.
O/D Gas cost This is the charges calculated based on the gas usage.
PwrGnGas ratio(%) This is the distribution ratio of gas used to generate power.
PwrGnGas usage(m3) This is the volume of gas used to generate power.
PwrGnGas cost This is the charges calculated based on the volume of gas used to generate power.
Total cost This is the total of “Elec. cost”, “O/D Gas cost”, and “PwrGnGas cost”.
E: The “PwrGnGas ratio”, “PwrGnGas usage”, and “PwrGnGas cost” items are added to the display when you touch this. This is not
possible if time distribution is set, however.
F: Display by area or by distribution group. (Factory setting: ON)
When this is cancelled, it is possible to display by area or by indoor unit. (→ “Changing the units of display” (P.74))
A
B
D
C
E F
Checking distribution data in a list
To Next Page
Loading...
