86
Settings for energy saving
Energy saving
6
Set other indoor units.
z Repeat steps 3 to 5.
7
Touch [Register].
z To cancel the settings, touch [Cancel].
7
Item Explanation
Timer The energy saving timer function is enabled
for the selected indoor unit if you put a check
mark here.
5
Touch [Register].
z The “Setting” dialogue closes.
z To cancel the settings, touch [Cancel].
5
The “Energy saving timer” screen
A: [Select all]/[Clear all] buttons
[Select all] Select all indoor units.
[Clear all] Cancel selection of all indoor
units.
B: Change list order. The list order changes
each time you touch it.
Display The display follows the order set
in “I/D unit settings” (P.141).
O/D unit The display follows the outdoor
unit display order set in “O/D unit
settings” (P.145).
Address The display follows the address
order set in “I/D unit settings”
(P.141).
C: The indoor units with a check mark next to
them will be the subject of the changes to the
settings.
D: The energy saving timer setting is enabled
for the selected indoor unit if you put a check
mark here. This is linked with the “Timer”
(“Setting” dialogue) setting.
E: The “Setting” dialogue is displayed when you touch this.
A
B
D
E
C
Restricting operating capacity according to the time slot [Energy saving timer]/[Efcient operation setting]
Note
y The settings for efcient operation (when using gas heat pump air conditioners) are made in the same way as energy saving timer.
To Next Page
Loading...
