92
Settings for energy saving
Energy saving
The “I/D unit demand settings” screen
A: [Select all]/[Clear all] buttons
[Select all] Select all indoor units.
[Clear all] Cancel selection of all
indoor units.
B: Set whether to enable indoor unit demand
control across the whole system or not.
Note
y If you select “Yes”, make sure that you set
“No” for outdoor unit demand settings.
C: Change list order. The list order changes
each time you touch it.
Display The display follows the order set
in “I/D unit settings” (P.141).
O/D unit The display follows the outdoor
unit display order set in “O/D unit
settings” (P.145).
Address The display follows the address
order set in “I/D unit settings”
(P.141).
D: The indoor units with a check mark next to
them will be the subject of the changes to the settings.
E: The I/D unit demand setting is enabled for the selected indoor unit if you put a check mark here. This is linked with the “I/D unit
demand Valid” (“Setting” dialogue) (P.90) setting.
F: The “Setting” dialogue is displayed when you touch this.
A
C
F
B
D E
Demand settings on the indoor unit [I/D unit demand settings]
To Next Page
Loading...
